Hangar-9 Pulse XT 40 ARF User Manual download pdf (Page 10)

  Step 9

Slide one of the longer pushrod wires into the wing.

Attach the servo extension to the “Z” bend of the

pushrod wire.

  Step 10

Pull the servo lead through the wing using the pushrod

wire. The lead will exit the hole on the top of the wing.

Use a piece of tape to keep the extension from falling back

into the wing.

  Step 11

Place the servo into the opening with the servo output

towards the trailing edge of the wing. Use a felt-tipped pen

to mark the locations for the four servo mounting screws.

  Step 12

Remove the servo and drill the locations for the servo

mounting screws using a 1/16" (1.5mm) drill bit.

Apply a couple drops of thin CA to each hole to harden

the wood, which will help in preventing the screws from

damaging the wood.

Section 1: Aileron Installation

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

No comments

Hangar-9 Pulse XT 40 ARF User Manual Page 10