Hangar-9 Pulse XT 40 ARF User Manual download pdf (Page 20)

Required Parts

• Fuselage

• 23

" (594mm) rudder pushrod

• 22

" (572mm) elevator pushrod wire

• Clevis w/retainer

Required Tools and Adhesives

• Drill • Felt-tipped pen

• Switch harness • Standard servo (3)

• Phillips screwdriver

• Drill bit: 1/16" (1.5mm), 5/64" (2mm)

Note: The throttle servo is not required when

building the electric version of your Pulse XT.

  Step 1

If you choose to use a glow engine, place the throttle

servo into the fuselage. Use a felt-tipped pen to mark

the locations for the four servo mounting screws on

the radio tray.

  Step 2

Use a 1/16" (1.5mm) drill bit to drill the locations for the

screws. Place a drop of thin CA into each of the holes to

harden the surrounding wood.

  Step 3

Secure the throttle servo using the hardware supplied with

the servo. Don’t forget to install the grommets and brass

eyelets before installing the servo.

Section 5: Servo Installation

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

No comments

Hangar-9 Pulse XT 40 ARF User Manual Page 20