Hangar-9 Pulse XT 40 ARF User Manual download pdf (Page 30)

 Step 4

Mount the engine to the mount using four 6-32 x 1

screws, four #6 washers and four 6-32 locknuts.

 Step 5

Slide a clevis retainer onto a clevis, and then thread the

clevis onto the throttle pushrod. Slide the pushrod into the

pushrod tube and attach the clevis to the carburetor arm.

 Step 6

Attach the pushrod connector to the throttle servo arm

using the connector backplate. You will need to enlarge

the hole in the servo arm using a 5/64" (2mm) drill bit.

 Step 7

Turn on the radio system and center the throttle stick and

trim. Slide the pushrod into the brass connector. Place the

servo horn onto the servo so the horn is perpendicular to

the servo centerline.

 Step 8

Use the radio to move the throttle to the low setting

using the stick and trim. Move the pushrod so the

carburetor is closed. Secure the pushrod wire using a

3mm x 5mm screw.

 Step 9

Check that the throttle operates from the radio without

binding at low and high throttle. Use the ATV setting

of the radio or change the position of the clevis at the

carburetor or the pushrod connector at the servo to

eliminate any binding.

Section 7B: Two-Stroke Engine Installation

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

No comments

Hangar-9 Pulse XT 40 ARF User Manual Page 30