Hangar-9 Pulse XT 40 ARF User Manual download pdf (Page 12)

  Step 18

Use a 5/64" (2mm) drill bit to drill the locations for the

control horn screws. Place a few drops of thin CA into

each hole to harden the underlying wood. This will help

in preventing the wood from crushing when tightening the

control horn screws.

  Step 19

Attach the control horn using two 2mm x 16mm screws, a

2mm x 12mm screw and the control horn backplate. The

shorter screw goes towards the trailing edge of the aileron.

 Step 20

Repeat Steps 1 through 19 for the remaining wing panel

and aileron.

Section 1: Aileron Installation

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

No comments

Hangar-9 Pulse XT 40 ARF User Manual Page 12