Hangar-9 Pulse XT 40 ARF User Manual download pdf (Page 7)

Warranty Information

Horizon Hobby, Inc. guarantees this kit to be free from defects in both material and workmanship at the date of purchase.

This warranty does not cover any parts damage by use or modification. In no case shall Horizon Hobby’s liability exceed

the original cost of the purchased kit. Further, Horizon Hobby reserves the right to change or modify this warranty without

notice. In that Horizon Hobby has no control over the final assembly or material used for the final assembly, no liability

shall be assumed nor accepted for any damage resulting from the use by the user of the final user-assembled product. By

the act of using the user-assembled product, the user accepts all resulting liability.

Once assembly of the model has been started, you must contact Horizon Hobby, Inc. directly regarding any warranty

question that you have. Please do not contact your local hobby shop regarding warranty issues, even if that is where you

purchased it. This will enable Horizon to better answer your questions and service you in the event that you may need any

assistance. If the buyer is not prepared to accept the liability associated with the use of this product, the buyer is advised

to return this kit immediately in new and unused condition to the place of purchase.

Horizon Hobby

4105 Fieldstone Road

Champaign, Illinois 61822

(217) 355-9511

Before Starting Assembly

Before beginning the assembly of the Pulse XT, remove each part from its bag for inspection. Closely inspect the fuselage,

wing panels, rudder, and stabilizer for damage. If you find any damaged or missing parts, contact the place of purchase.

If you find any wrinkles in the covering, use a heat gun or sealing iron to remove them. Use caution while working around

areas where the colors overlap to prevent separating the colors.

Using the Manual

This manual is divided into sections to help make assembly easier to understand, and to provide breaks between each

major section. In addition, check boxes have been placed next to each step to keep track of each step completed. Steps

with a single box (

) are performed once, while steps with two boxes ( ) indicate that the step will require

repeating, such as for a right or left wing panel, two servos, etc. Remember to take your time and follow the directions.

HAN100 – Heat Gun

HAN150 – Covering Glove

HAN101 – Sealing Iron

HAN141 – Sealing Iron

Sock

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

No comments

Hangar-9 Pulse XT 40 ARF User Manual Page 7