32
Required Parts
• Fuselage • Wing
• Wing bolt plate • Wing tube
• 1/4-20 x 1
1
/
2
" nylon bolt (2)
• 1
7
/
8
" (48mm) wing dowel (2)
• 1
5
/
16
" (33mm) wing dowel
• 2mm x 8mm sheet metal screw (4)
Required Tools and Adhesives
• Thin CA • Phillips screwdriver
Step 1
Cut the instrument panel decal from the decal sheet.
Apply the decal in position for the instrument panel
in the cockpit.
Step 2
Use four 2mm x 18mm screws to secure the canopy onto
the fuselage. Make sure the rear screws are going into
solid wood before installing them.
Step 3
Apply any remaining decals onto the aircraft using either
the box for location or your imagination.
Step 4
Slide the 1
7
/
8
" (48mm) wing dowel into one of the wing
panels. Leave 3/8" (10mm) of the dowel extended out
from the leading edge of the wing. Apply thin CA to the
dowel at the leading edge. You will also see a small
portion of the dowel exposed inside the wing. Apply thin
CA to the dowel inside the wing as well.
Step 5
Slide the wing tube and the 1
5
/
16
" (33mm) wing dowel
into one of the wing panels.
Section 8: Final Assembly
Comments to this Manuals