8
Required Parts
• Wing panel (right and left) • Aileron (right and left)
• Servo w/hardware (2) • Clevis w/retainer (2)
• CA hinge (8)
• Servo extension, 6" (152mm)
• Aileron linkage, 4" (102mm) (2)
• Control horn w/backplate (2)
• 2mm x 16mm screw (4)
• 2mm x 12mm screw (2)
Required Tools and Adhesives
• Thin CA • Drill
• Hobby knife • Felt-tipped pen
• T-pins • Phillips screwdriver
• Drill bit: 1/16" (1.5mm), 5/64" (2mm)
Step 1
Locate four CA hinges. Place a T-pin in the center of each
of the four hinges.
Step 2
Use a 1/16" (1.5mm) drill bit to drill a hole in the center of
each hinge slot. Drill holes for both the wing and aileron.
Note: The hole will allow the CA to penetrate
the hinge farther into the surface, providing
a better bond between the hinge and wood.
Step 3
Slide the hinges into the aileron. The T-pins will rest
against the hinge line of the aileron.
Step 4
Slide the aileron onto the wing. Press the aileron
tightly against the wing, and then remove the T-pins
from the hinges.
Section 1: Aileron Installation
Comments to this Manuals