9
Step 5
Position the aileron so it can move freely and not
bind at the wing tip or wing root. Deflect the aileron
without changing the hinge gap, and apply thin CA to
each of the four hinges. Apply CA to both the top and
bottom of the hinges.
Note: Do not use CA accelerator
on the hinges; the CA must be
allowed to soak into the hinge.
Step 6
Once the CA has fully cured, gently pull on the aileron to
make sure the hinges are secure. Avoid too much pressure
which could cause damage to the wing and aileron.
Step 7
Flex the aileron up and down a number of times to break
in the hinges.
Step 8
Prepare an aileron servo by installing the grommets
and brass eyelets provided with the servo. Secure
a 6" (152mm) servo extension to the servo using a
commercially available connector or with string or
unwaxed dental floss.
Section 1: Aileron Installation
Comments to this Manuals