Hangar-9 Pulse XT 40 ARF User Manual download pdf (Page 34)

The amount of control throw should be adjusted as closely

as possible using mechanical means, rather than making

large changes electronically at the radio. By moving

the position of the clevis at the control horn toward the

outermost hole, you will decrease the amount of control

throw of the control surface. Moving it toward the control

surface will increase the amount of throw. Moving the

pushrod wire at the servo arm will have the opposite

effect: Moving it closer to center will decrease throw,

and away from center will increase throw. Work with a

combination of the two to achieve the closest or exact

control throws listed.

Aileron

Low Rate Up Down

11/32" (9mm) 11/32" (9mm)

High Rate

1/2" (13mm) 1/2" (13mm)

Elevator

Low Rate Up Down

1/2" (13mm) 1/2" (13mm)

High Rate

7/8" (22mm) 7/8" (22mm)

Measured at the trailing edge of the elevator.

Rudder

3/4" (19mm) Left

3/4" (19mm) Right

The rudder throw is measured at the counter

balance using the top of the fin as a reference.

Once the control throws have been set, use the supplied

tubing on each clevis to prevent them from opening

during flight.

Control Throws

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

No comments

Hangar-9 Pulse XT 40 ARF User Manual Page 34