Hangar-9 Pulse XT 40 ARF User Manual download pdf (Page 16)

 Step 6

Test fit the rudder and fin together. Make sure to insert the

tail gear wire into the rudder. When satisfied with the fit,

mix up a small amount of 6-minute epoxy and apply it to

the tail gear wire and the corresponding hole in the rudder.

Slide the rudder back into position against the fin.

 Step 7

Position the rudder control horn 5/8" (16mm) up from the

bottom of the rudder. With the holes in the horn aligned

with the hinge line, mark the locations for the control horn

screws. Drill the locations using a 5/64" (2mm) drill bit.

After placing a few drops of thin CA into each hole, secure

the control horn using three 2mm x 12mm screws.

Note: The horn will be on the right side

of the plane from the pilot’s perspective.

 Step 8

Attach the tail wheel using the 2mm wheel collar

and setscrew. Use threadlock on the setscrew to prevent it

from coming loose in flight due to vibration.

Section 3: Hinging the Rudder

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

No comments

Hangar-9 Pulse XT 40 ARF User Manual Page 16