21
Step 4
Repeat Steps 1 through 3 to install the rudder and
elevator servos.
Step 5
Install the switch harness on the side of the fuselage using
the switch harness hardware.
Step 6
Wrap the receiver and receiver battery in 1/4" (6mm)
foam to protect them from engine vibrations.
Step 7
Plug the servos, extensions and switch harness into the
receiver. Plug the receiver battery and switch harness
together. Place the receiver and receiver battery into the
fuselage.
Step 8
Route the receiver antenna to the rear of the fuselage
using the pre-installed antenna tube.
Note: Do not cut the excess antenna wire as
it will reduce the range of your radio system.
Section 5: Servo Installation
Comments to this Manuals