Hangar-9 Pulse XT 40 ARF User Manual download pdf (Page 28)

 Step 9

Remove the hatch from the bottom of the fuselage. Slide

the battery tray into the fuselage with the hook and loop

facing towards the bottom. The rear of the battery tray

will key into the former. Use two 4-40 x 3/8" socket head

screws to secure the front of the battery tray.

 Step 10

Plug the motor into the speed control. Place the mating

half of the self adhesive hook and loop onto each of the

batteries. Secure the batteries using the hook and loop

strap. Plug the speed control into the receiver. Mount the

speed control inside the fuselage so it will not interfere

with the installation and removal of the batteries.

 Step 11

Turn on the radio system. Plug the wiring harness

assembled in Step 4 into the batteries and speed control.

Use the throttle on the transmitter to check that everything

is working correctly. Check that the motor is rotating

counterclockwise. If not, follow the directions included

with the speed control to correct the situation.

 Step 12

Once the motor is working and rotating in the correct

direction, unplug the wiring harness for safety. Snap the

battery hatch back onto the fuselage.

 Step 13

Trim the cowling as necessary to fit over the motor. The

cowl is mounted using four #2 x 1/2" sheet metal screws.

Install the propeller and spinner using the instructions

included with your particular motor.

Section 7A: Electric Motor Installation

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

No comments

Hangar-9 Pulse XT 40 ARF User Manual Page 28